1968 z28 fan blade

**Charley Lillard** · #1 08-28-2007, 12:46 AM

Here you go.

firez · #2 08-28-2007, 02:18 AM

Thanks that is the one that was in the trunk of my z when I bought the car and the engine had a flex fan on it. Nice to know I have the correct one.

3macs1 · #3 08-28-2007, 02:36 PM

Check the hole diameter to make sure it is 2 5/8 inches. There is another fan that looks identical to this in 68 also a 4 rivit but has a smaller hole diameter and not correct for the Z.

firez · #4 08-28-2007, 04:05 PM

I will measure it when I get home,never knew that.

**Charley Lillard** · #5 08-28-2007, 06:00 PM

size...3 1/4" bolt spacing

**427.060** · #6 08-28-2007, 08:09 PM

Don't mean to change the subject here but I have always wondered why the spacing on factory fan blades is not even.
James

bigchevydaddy · #7 08-28-2007, 08:46 PM

OK, so who taught Charlie how to use a ruler? Figuring out that measurement involves higher math!

Dedicated to the Promotion and Preservation of American Muscle Cars, Dealer built Supercars and COPO cars.