Sub Frame question ?

Home: Goto Homepage.
Subscribed: See all threads you’ve posted in or started.
Today's Posts: Posts made today. Bold = unread.
New Posts: Shows all unread posts since last visit.
New Thread: Newest threads by creation time.

hugger1 · #1 02-19-2002, 01:25 PM

Thanks for the help SS427.

I really enjoy this site .
there are some very knowledgable people here and after talking to a few , very friendly and helpful to.

COPO PETE · #2 02-19-2002, 08:52 PM

Not sure how big these "plates" are you made, but genrally if you buy the correct size washer from a hardware store, all you have to do is weld them in place and grind down the weld. The hole then is perfect.
Peter

hugger1 · #3 02-20-2002, 02:52 AM

Thanks COPO Pete .

I made a template of the top of the mounting perch and cut them to fit ( using a plasma cutter , then tacked the right & left together and ground edges so they are the same.

Its all Mig welded and ground down so it looks right.
Used a Hole saw to cut correct size for bushing and then drilled the aligning hole the correct size as well.

The washer would have been easier though.

Dedicated to the Promotion and Preservation of American Muscle Cars, Dealer built Supercars and COPO cars.