Welding Muncie handle to Hurst shifter????

Home: Goto Homepage.
Subscribed: See all threads you’ve posted in or started.
Today's Posts: Posts made today. Bold = unread.
New Posts: Shows all unread posts since last visit.
New Thread: Newest threads by creation time.

**Mr70** · #1 10-26-2020, 11:49 PM

Quote:

It will sit a little higher than stock,but you'll be the only one that knows it.

Not anymore..

crash · #2 10-27-2020, 03:49 PM

I don't know if you know this, but the Hurst after market shifter for the 1967-68 and the 1969 Camaro's, all the installation kit are based off the small block location...

The shifter mounting plates don't take into account the motor and trans being moved 1/2" forward and 1/2" to the right for the big block application...

Some people say there isn't a problem, then there are the people that call me for this very problem...

If you have a problem I have a mount that addresses this very problem for both the 1967-68 and the 1969 big block Camaro's for both the 27 spline and 32 spline tail housings

Hope this helps... Crash

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Hybrid Mode Switch to Threaded Mode

The Following 5 Users Say Thank You to crash For This Useful Post:
169indy (10-27-2020), Hrlyfxdl (01-18-2023), SeattleCarGuy (10-27-2020), x Baldwin Motion (10-28-2020), Xplantdad (10-27-2020)

Dedicated to the Promotion and Preservation of American Muscle Cars, Dealer built Supercars and COPO cars.