Value question - 1967 427 engine

[427.060]

The square port heads may be worth more than the rest of the engine. You need to get the casting numbers and dates for the heads.
James

[olredalert]

-----The Corvette boys will love to get hold of that two-bolt main 351 block. There are plenty of 390 and 400 horse Vette owners around that will pay good money for your short-block.........Bill S

[b4cmaro]

Well, now I have a bit more info

block is definitely the 351 casting (not sure what the guts are)
069 intake
drivers side head is casting 3964291 w/ date of E 23 70
pass side head is casting 3904391 w/date of D 8 7

In a very rough '69 chevelle with a M20 (69 dated muncie but not original to the car) and a non-posi 12 bolt (CA code) and a tilt column

Can be bought for $5500 - just not sure if I'd make any money parting it out.

Opinions?

[427.060]

The 291 head should bring $350-500 on Ebay. The 391 might bring as much as $2000. About another $350-500 for the intake. Another $2000-3000 for the short block. How many resalable parts are left on the car? Is it an SS? Tilt column would bring a few hundred more. Disc brake car?
James

[b4cmaro]

Thanks for the input!
Not an SS - just a bench seat Malibu
All the glass is good, but I didnt check date codes
interior could clean up for a decent driver, but the front bench is blue, rest is black.
All the front end has been rebuilt, shame to waste it, but I wouldnt be into selling off each A-arm etc.

[Tarrytown SS427s]

Can you post the casting date off the side of the block? I will check my Doraville, GA 67 B-body list later and see if I have than vin number listed.
Steve