Dedicated to the Promotion and Preservation of American Muscle Cars, Dealer built Supercars and COPO cars. |
|
|
|
#1
10-23-2007, 05:46 PM
|
||||
|
||||
Re: Is it me or ?
Weapon for sure...but car 000012!
 .Too bad the cowl tag's missing.. ~ Pete 
__________________
I like real cars best...especially the REAL real ones! 
|
|
#3
10-25-2007, 05:48 PM
|
|||
|
|||
|
Re: Is it me or ?
When doing a major model change in Oshawa, the first few cars built didn't get VIN tags. Once the body shop got the metal fitting properly, then they built cars with VINS to sell to the public. The no VIN cars were used as "yard cars" around the plant for a few years. Many were given to schools with auto tech classes. This gave the kids something to get hands on experience with. It was possible that some of these eventually snuck out the back door and onto the street. As far as the location of the rear wheels in the wheel opening, you would have to do a real butcher job to get the quarters that far off. It has to be the location of the rearend. Even the rear axle tubes locate on pins in the springs. Weird.
__________________
Chevelleless after 46 years......but we did find a low mileage, six speed, silver 2005 Corvette. It will just have to do for now. 
|
|
#4
10-26-2007, 12:00 AM
|
||||
|
||||
|
Re: Is it me or ?
All it takes is for that little 1/2 locater pin to break and the rear will slide fore and/or aft of its original position. That looks like what happened here. It must be fun to watch going down the street sideways dogtracking.
|
|
#5
10-26-2007, 12:12 AM
|
|||
|
|||
|
Re: Is it me or ?
[ QUOTE ]
All it takes is for that little 1/2 locater pin to break and the rear will slide fore and/or aft of its original position. [/ QUOTE ] Or, if you use a Mr. Gasket shim to correct your pinion angle, the pin rests in the hole in the shim, thus doing away with the locating pin...
|
|
#6
10-26-2007, 01:33 AM
|
||||
|
||||
|
Re: Is it me or ?
[ QUOTE ]
[ QUOTE ] All it takes is for that little 1/2 locater pin to break and the rear will slide fore and/or aft of its original position. [/ QUOTE ] Or, if you use a Mr. Gasket shim to correct your pinion angle, the pin rests in the hole in the shim, thus doing away with the locating pin... [/ QUOTE ] What do you do then?
__________________
Marlin 70 Yenko Nova-350/360, 4speed M21, 4.10 Posi (Daddy's Ride) 69 SS Nova-396/375hp, 4speed M20, 3.55 Posi (Benjamin's Ride) 67 RS Camaro-327/250hp, 2speed Glide, & 3.08 Open (Danny's Ride)
|
 |
|
|
Just a guess.
Hybrid Mode
