Garage Advise Question 2

Home: Goto Homepage.
Subscribed: See all threads you’ve posted in or started.
Today's Posts: Posts made today. Bold = unread.
New Posts: Shows all unread posts since last visit.
New Thread: Newest threads by creation time.

**mockingbird812** · #1 05-17-2007, 03:37 AM

Sweat the pipes just like H2O is running thru them. As mentioned my primary lines are 3/4" and my drops are 1/2".

**lbnaz** · #2 05-17-2007, 08:01 AM

Hello, Ed I'm a union pipefitter. Run the header in 3/4" and the drops in 1/2" type L copper. Sweat the joints using Silvabrite lead free solder. Don't forget to clean the pipe and fitting prior to applying flux. Then solder it as you would a water pipe joint. Secure it good on the wall with strut and cush clamps and you'll never have a problem. I'm in Tucson if you want to check mine out. It will hold all the pressure you will be putting in it. Call me if you need imfo or help. Larry.

**enio45** · #3 05-18-2007, 02:59 AM

excellent larry - thanks a million for the advise

Dedicated to the Promotion and Preservation of American Muscle Cars, Dealer built Supercars and COPO cars.