What caused this? - Page 2

**PeteLeathersac** · #11 12-21-2006, 02:06 AM

[ QUOTE ]
I...we spent this past Sunday afternoon hand-sanding the rear diff. Can't beat the father-son time!

[/ QUOTE ]

Magic stuff Marlin!!! .

~ Pete

**Xplantdad** · #12 12-21-2006, 02:13 AM

I might as well get some use (mileage) out of my screen capture...don't you think?

Kim_Howie · #13 12-21-2006, 08:50 PM

Is the crank snout chewed up any?? Any indents in the snout??

**YENKO DEUCE REGISTRY** · #14 12-21-2006, 09:15 PM

No, the only issue with the crank is that the keyway is mushroomed a tiny bit at the edges. So, I plan to file that down, and reinstall the balancer.

Kim_Howie · #15 12-21-2006, 09:41 PM

Put some loctite on the bolt threads and you should be OK.

BUIZILLA · #16 12-21-2006, 11:14 PM

Marlin, get a threaded balancer puller tool when installing it the next time, if you don't already have one...

JH

**YENKO DEUCE REGISTRY** · #17 12-22-2006, 03:12 AM

Good advice, I initially installed it via the center bolt. This time, I will purchase a balancer installer tool, and will use loctite on the threads.

**Salvatore** · #18 12-22-2006, 08:52 AM

Use a 5 lb sledge and a piece of 2X4. Just tap it evenly! Come on!

**YENKO DEUCE REGISTRY** · #19 12-22-2006, 06:00 PM

Been there, done that

I'd rather do it the 'civilized' way this time.

**Salvatore** · #20 12-22-2006, 06:53 PM

That is civilized. We used to use a 10lb hammer!

One shot and done.