subframe bushing tape...

[Tommy_Mathison]

Rick, that is the same place all of the tape is that I have seen. Now did the tape extend down from the top on the bushing/subframe onto the sides of the subframe (left and right of the subframe in your pic)? If so, was only the top bushing held into place then? I apreciate the help guys.

Tommy M

[Rick H]

I don't believe it goes down on to the sides of the subframe. I can look when I get home Friday night and post what I see.

Rick H.

[Tommy_Mathison]

If it didn't hold the upper bushing to the subframe then what does it tape, or what was its purpose?

Tommy M.

[Rick H]

I looked at the tape on my car and it looks like it was used to hold the upper bushing to the floor. If it was used to hold the bushing to the subframe then there must be a lot of tape missing.
Interesting to note is that I do not see any evidence of tape on the drivers side. My floors, subframe and bushings are original to the car so.

Another neat piece on my car is that there are two small rubber pieces taped to the center e-brake cable to keep it from rubbing on the floor. Plus all the original spring tags are still on the car.

Rick H.

[Tommy_Mathison]

If the tape held the bushing to the floor, that means it would have to have been double sided tape. This is way confusing. I'm going to keep digging.....

Tommy M

[NCGuy68]

I've parted out quite a few Camaros over the years, both Van Nuys and Norwood. Never seen any Sub-Frame bushing tape to speak of. I have seen evidence of tape on early 'Vettes' from the St. Louis plant

Please post clear photos of any Camaro S-Frame Bushing Tape that might be OEM. Thanks for your help.

[KENNY_PASCOE]

IF SOMEONE HAS PICS OF MY OLD 18K MILE 69 Z/28 THAT CAR CLEARLY HAD TAPE UNDER THE BUSHINGS. CALLING DARREN, I KNOW YOU HAVE PICS.... KP