Dedicated to the Promotion and Preservation of American Muscle Cars, Dealer built Supercars and COPO cars. |
|
|||||||
| Register | Album Gallery | Thread Gallery | FAQ | Community | Calendar | Become a Paid Member | Today's Posts | Search |
|
|
|
Thread Tools | Display Modes |
|
|
|
#1
02-25-2006, 06:52 AM
|
|||
|
|||
Re: Boring out a AMC 390 - .60 over - ????
If you are concerned about going .060 over, consider sleeving each cylinder. then, you can either bring it back to standard bore, or go over .10,.20 etc. I drag raced a small block chevy
extensively that was sleeved, then bored to yield 355 cubic inches with no problems.
__________________
Dean 
|
|
|
|
Hybrid Mode
