![]() Dedicated to the Promotion and Preservation of American Muscle Cars, Dealer built Supercars and COPO cars. |
|
#1
|
|||
|
|||
![]()
Nice combo,but that tag looks suspect and no paper,run away?
http://cgi.ebay.com/ebaymotors/ws/eB...tem=4603329540 |
#2
|
||||
|
||||
![]()
What's wrong with the tag. I think it's ok.
__________________
1969 Z28 1972 Corvette |
#3
|
|||
|
|||
![]()
Looks OK to me.
![]() |
#4
|
|||
|
|||
![]()
We need Rick H to critique this one.
|
#5
|
||||
|
||||
![]()
Nice Car, I see it's got my fan shroud from hell on it.
![]() ![]() |
#6
|
||||
|
||||
![]()
The car is definitely different.
__________________
Nick... |
#7
|
|||
|
|||
![]()
There is nothing wrong with the tag on the car. VIN matches build date.
There are however some small items that are wrong. Alternator, water pump (could be a mistype), fan shroud, master cylinder, wrong shifter and knob, radio is wrong, should have slide on top for AM/FM selection, no rear bumper guards. Since there is no numbers for the carb and because the way the PCV hose is routed I would say it's not correct. Bunch of little incorrect items but the car looks good. Missing smog would be expensive to correct. Wrong exhaust (but how many really have the correct exhaust). You could pick on it for all the small stuff but the car is nice. It even has the correct and they look like the original fenders. ![]() Rick H. |
#8
|
|||
|
|||
![]()
Don't get me wrong the car is sweet but there's no dum dum in the rivet holes,definitely been off at one point then this one leaves you a little less confident-
"IT WILL BE UP TO THE BUYER TO EVALUATE AND DECIDE IF THIS CAR IS AS AUTHENTIC AS WE THINK IT IS. STARTING FROM THE TRIM TAG, WE BELIEVE IT IS DEFINITELY THE ORIGINAL TAG BORN TO THIS CAR." Does that allow for a rebody? ![]() |
#9
|
||||
|
||||
![]()
[ QUOTE ]
Don't get me wrong the car is sweet but there's no dum dum in the rivet holes,definitely been off at one point then this one leaves you a little less confident [/ QUOTE ] I have seen 2nd gens with out sealer in the holes. My 72 doesn't have any and I know the tag has never been off.
__________________
1969 Z28 1972 Corvette |
#10
|
|||
|
|||
![]()
I have no sealer on my 70 Z28 tag holes and I'm the 2nd owner and know it's orig.
Wrong pcv hose, wrong oil breather hose, incorrect cig lighter, should not have a front spoiler, missing chrome tailpipes, wrong plug wire boots, wrong rad cap, looks like it's missing the corner rubber bumpers in each corner of the rear bumper. All Norwood cars should have the Z28 on the tag unless it's been swapped with a LA tag or remade incorrectly. The holes in the tag are too darn clean for a driver. Missing emblem on trunk lid too. Bad dash fit to the A pillar, I see wires on the drivers side. Can't afford the vette flags on the valve cover? Missing TCS wires on the pass head along with the temp sensor for the TCS. Missing upper rubber door stopper on both doors. Missing blue GM VIN Certification sticker on the drivers door. I see yellow paint on the pass side lower dash beside the upper air vent. |