restoring frame questions

Home: Goto Homepage.
Subscribed: See all threads you’ve posted in or started.
Today's Posts: Posts made today. Bold = unread.
New Posts: Shows all unread posts since last visit.
New Thread: Newest threads by creation time.

rusted goat · #1 01-31-2005, 07:25 PM

Few questions about restoring a frame for a concours show car (71 Judge)
1. stainless brake and fuel lines
2. poly control arm bushings
3. bolted in upper balljoints
4. powercoating frame and a arms
5. exhaust stainless
I can go with rubber and steel but I was wondering what everyone else is doing in these areas

Thanks this site just pushed me into getting started on a long overdue restoration

**Alss** · #2 01-31-2005, 11:04 PM

Just finished my COPO frame..painted frame and arms, stainless lines, bolted ball joint ( for now ), poly bushings and I'm not sure what the Gardener exhaust sytem is but that is what I am going to use. I have doen a frame in powder coat and it is very nice but a good frame is a must to start with. good luck.

Check it out:
https://www.yenko.net/ubbthreads/show.../page/0#117334

ALbert

Dedicated to the Promotion and Preservation of American Muscle Cars, Dealer built Supercars and COPO cars.