What headers?

[JoeG]

The Eastwood Stainless steel paint works well with occasional minimal touch up--I'm guessing the por coating is similar----For maintenace free headers you can't beat the ceramic type coatings,I think they make one that has a satin stainless finish---- Rob---I don't think there's any powder coating that will handle heat demands of headers It's a shame---White headers look so

[427TJ]

Butch Leal's Pro Stock '70 Camaro with Cragars. 11/70 Cars cover. (No story on Leal's car inside, just the cover shot.)

[427TJ]

Bill Jenkins' Pro Stock '70 from an Edelbrock ad. (The ad was originally printed with lines through the image.)

[427TJ]

The ladies seem to prefer Hedman Hedders...

[427TJ]

Big Willie says "Buy American!" Better do what he says...

[hvychev]

Very cool Big Willie ad!

[427TJ]

One of my favorites from 25 years ago. The 'Crystal Blue Persuader' as seen on the cover of the 1980 Car Craft Camaro Celebration #2. Too bad the bar code got in the way.

[budnate]

there is a place in town that alumacoats them white or used to???? epa may have got them...only thing they have a little texture at that point...I did many sets in the 80's and they always looked great..the tubes by the ground would get a little brown from the rain as they were on daily drivers..but stayed nice and white up by the heads...Sam, give Machinist Inc a call and see if they still do it if you want to go that way..if I recall they used to charge about 80 bucks if they were clean when you dropped them off...much more if they had to clean them.