Dust I can clean off. I will be getting the body back once all the sheetmetal work is complete and in primer. That way I can dust it off and install the rest of the exhaust, the fuel tank, fuel lines, etc.
I was dead in the water for a while due to the trunk floor not having been fixed, so ENOCH decided to replace the trunk floor, so I could do some more stuff on it myself. When he decided to keep going after fixing the trunk floor, I wasn't about to stop him.
Here are some shots from this morning. They carefully masked off the underside to keep the overspray away and primered (with low air pressure) the small section underneath the trunk floor. Eventually the "newer" red primered section will be very hard to tell from the original primered area. Plus, the majority of the replaced trunk floor section is blocked from view by the gas tank.
03-06-2008, 02:09 AM
Re: 72 T/A progess
Threaded Mode