Why a white bottom?

[68l30]

I've seen the same thing with axle shafts,thet will twist sometimes 180 degrees!Thats torque!Anyone else gone to the old school?

My Dad's 70-1/2 E/Stock Camaro had the firewall, bottom of the hood, and the underbody painted white for various reasons but mainly it was to reflect light. Some tracks he visited had very poor lighting at night, and when using only a drop light to work under the car, the light color allowed more light under the car as opposed to a dark color. (the car was a factory black car)The inside of the trunk and underdash were also painted white for the same reasons. He also painted the fuel tank white, so while sitting in those long staging lanes that were blacktopped, Bristol specifically, the white paint would reflect the heat from the pavement. Thus keeping the fuel cooler than if the tank was black. Just thought I would throw my two cents worth into this......Rat Pack...

[bowtie3168]

Marlin,
I asked Bill Jenkins that same question at the "Mopar Parts Nationals" a few years ago. Mr. Jenkins told me that they did it so that they could work on the car easier while match racing. He said that when they would match race at some "back wood" tracks there would be little or no lighting, when the underside was white a small light would increase visability greatly. Bill also told me some of the "tricks" that they would use to stay ahead: they used a generator instead of a alternator, they would switch the generator off during the run and switch it on right after. The car had one airbag inside of one of the rear coil springs. Dave Strickler's Z-11 is thought to be #1, its aluminum hood has an unpainted underside.
Andrew

[YENKO DEUCE REGISTRY]

The responses are very interesting! I wish there were still old back woods tracks operating today. I am tired of waiting 4 hours on grudge night to get two runs in!
M