Dedicated to the Promotion and Preservation of American Muscle Cars, Dealer built Supercars and COPO cars. |
|
|||||||
| Register | Album Gallery | Thread Gallery | FAQ | Community | Calendar | Become a Paid Member | Today's Posts | Search |
|
|
|
Thread Tools | Display Modes |
|
#1
04-21-2025, 02:18 PM
|
||||
|
||||
Distributor restoration
Who is everyone using for distributor restoration?
|
|
#2
04-21-2025, 02:30 PM
|
||||
|
||||
|
Jerry M? I know Don Baker retired and to my knowledge nobody picked up his business
|
| The Following User Says Thank You to napa68 For This Useful Post: | ||
RPOLS3 (04-21-2025) | ||
|
#3
04-21-2025, 02:34 PM
|
|||
|
|||
|
Mike Gibbons one of our sponsors can have your distributor restored.
__________________
1966 Corvette Coupe L79 Mossport Green 1969 Camaro Z/28 Hugger Orange NCRS #22211
|
| The Following User Says Thank You to mhm1966 For This Useful Post: | ||
RPOLS3 (04-21-2025) | ||
|
#4
04-23-2025, 03:55 PM
|
||||
|
||||
|
I reached out to both Jerry and Mike via e-mail and did not get a reply from either...........I decided to have my mechanic buddy who has a Sun machine install new points and dial in the advance curve, the bushings seem fine. I will clean up and paint the cast iron body along with installing a new brass contact cap and rotor when I get it back and see how that works out.
|
| The Following 5 Users Say Thank You to RPOLS3 For This Useful Post: | ||
CamarosRus (04-23-2025), dykstra (04-23-2025), mhm1966 (04-25-2025), napa68 (04-23-2025), olredalert (04-23-2025) | ||
|
#5
04-25-2025, 01:37 PM
|
|||
|
|||
|
I just had mine redone by Jerry M and am happy, but if I knew someone with a Sun machine I would have gone that route too.
__________________
Bill Pritchard 73 Camaro RS Z28, L82, M20, C60
|
|
#6
04-25-2025, 05:15 PM
|
||||
|
||||
|
I've had Jerry M do a few for me over the years. In one case, I dropped-off the distributor at the post office on Monday and it was sitting on my dining room table when I got home from work the following Friday. Not a typical case I'm sure but was impressed. Here's the latest he did for my 67:
Last edited by juliosz; 04-25-2025 at 06:34 PM.
|
| The Following 3 Users Say Thank You to juliosz For This Useful Post: | ||
|
#7
04-25-2025, 06:20 PM
|
|||
|
|||
|
Jerry McNeish did my 69 Z-28 Distributor. He did a great job, highly recommend.
|
| The Following User Says Thank You to RALLY For This Useful Post: | ||
RPOLS3 (04-27-2025) | ||
|
|
|
Linear Mode
