1962 Corvette 327-340hp 4 Speed

[napa68]

Originally Posted by Too Many Projects

Hmmm... I don't recall/remember seeing what you acquired for a trailer, Tim....

I ordered a 24ft Featherlite at the 1st of the year. It came in a few weeks ago. So far, I'm impressed with the unit.

[Too Many Projects]

VERY nice !! and light. You have the facility to clean it after salt use too. Should look like new for a long time.
Just noticed the fender well comes out too for floor to ceiling escape. That will be nice for the low cars.

[napa68]

Originally Posted by Too Many Projects

Just noticed the fender well comes out too for floor to ceiling escape. That will be nice for the low cars.

Fat guy friendly too

[napa68]

Now that I'm back from Iowa, I can get back on the 62. I cleaned up all of the old grease in the shifter, lubed it up, mocked and adjusted it on the trans. Just got back from a 15 mile test ride......works perfect now.

62 degrees and sunny as I write this. Kinda hard not to say the hell with it and just ride around today

[Too Many Projects]

Glad the trans issue is behind you, and I hope you put a couple hundred miles behind you with the nice weather too...
Spent my day busting my butt to get primer/sealer on the Camaro floor...but, hey, I was outside to do that.. LOL

[napa68]

Now that I'm back from my recent NCRS events, and I got my head above water on some of the customer work.......I had a chance to get back on to the 62. The carb is back from Rob Kunz, so I could get that installed and lay down a final tune. I'm thrilled with how the car runs!

Did some small tweaks as well. Lubed up the window regulators, lubed up the heater cables, and threw a hundred miles on in the last couple of days.

In the next few weeks, I'll get the car photographed and see what I am going to do with it. I've really been enjoying the car.......hate to see it go away