Dedicated to the Promotion and Preservation of American Muscle Cars, Dealer built Supercars and COPO cars. |
|
|||||||
| Register | Album Gallery | Thread Gallery | FAQ | Community | Calendar | Become a Paid Member | Today's Posts | Search |
|
|
Thread Tools | Display Modes |
|
#11
10-24-2023, 11:13 AM
|
||||
|
||||
Thanks guys! I don't remember if these were PLA or ABS. I know about the smoothing over technique but just haven't tried it yet. I'll give it a go on the next batch of parts.
 A note on the hardtop is that since each car was hand made, each one was made to fit each car and would ONLY fit that car. With all the subtle differences with hand forming cars, a hardtop from another car won't fit any other car. Coincidentally, it's the same with mine. My hardtop will not fit any other 507 Replica!   I know, I’m striving for correctness even in incorrect correctness! Finishing up the interior A-Pillar finish garnish molding with visors and a rearview mirror next week. Cheers Dave Last edited by A12pilot; 10-24-2023 at 11:18 AM. 
|
| The Following 12 Users Say Thank You to A12pilot For This Useful Post: | ||
69M22Z (10-24-2023), big gear head (10-24-2023), Charley Lillard (10-24-2023), dykstra (10-24-2023), L78_Nova (10-30-2023), L_e_e (10-25-2023), markinnaples (10-24-2023), olredalert (10-24-2023), PeteLeathersac (11-04-2023), RPOLS3 (10-24-2023), Woj (10-25-2023), Xplantdad (10-24-2023) | ||
|
|
Threaded Mode