68' Chevy II build thread

**Crossbreed383** · #1 06-15-2023, 02:40 PM

Finally time for some DTM primer for all the bare spots and then I used some Polyester primer to help not only get things super straight after blocking but it helps seal in any old substrate.

**Crossbreed383** · #2 06-15-2023, 02:44 PM

Some more pics

**Crossbreed383** · #3 06-15-2023, 02:46 PM

1st coat of Polyester primer

**Crossbreed383** · #4 06-15-2023, 02:49 PM

Guide coat and block time !!!!!

**Crossbreed383** · #5 06-15-2023, 02:53 PM

The BOSS even helped out with the tedious sanding. My wife helped sand and did all the jambs, and under hood and trunk areas.. She earned a new found appreciation of the old adage.." (The harder it is to sand, the more important it is !) " She's a rock star !!

**Crossbreed383** · #6 06-15-2023, 03:11 PM

Some pics of the wife's jam work and before old door pins were removed /replaced.

**Crossbreed383** · #7 06-15-2023, 03:15 PM

Some more pics before/after final 2k panel priming ...

The Following 2 Users Say Thank You to Crossbreed383 For This Useful Post:
69M22Z (06-15-2023), dykstra (06-15-2023)

The Following 3 Users Say Thank You to Crossbreed383 For This Useful Post:
69M22Z (06-15-2023), dykstra (06-15-2023), L78_Nova (06-16-2023)

Dedicated to the Promotion and Preservation of American Muscle Cars, Dealer built Supercars and COPO cars.