Intake manifold fit after decking block

Home: Goto Homepage.
Subscribed: See all threads you’ve posted in or started.
Today's Posts: Posts made today. Bold = unread.
New Posts: Shows all unread posts since last visit.
New Thread: Newest threads by creation time.

**big gear head** · #1 02-16-2023, 07:16 PM

If they only remove about .010 from the deck you shouldn't have any problems.

**DAVE H** · #2 02-16-2023, 09:01 PM

It's when the heads get over milled that you run into problems. Found that out the hard way with a set of 074's. Ended up having to mill the intake gasket surfaces to get it to sit down between the heads and gaskets. Those heads were milled down to where the edge of the intake valve seats were also being cut.
Dave.

Dedicated to the Promotion and Preservation of American Muscle Cars, Dealer built Supercars and COPO cars.