69 small block mount info

[Zman1969]

Originally Posted by X66 714

That's in my car now, yes. I was comparing hdw between small block & big block. It seems to me that all the pieces were different. I'll have to go back & look. I also remember looking for the part numbers in AMK before I contacted Rich. I'll see if I can do some digging for sizes of hdw. I'm reaally surprised that somebody else hasn't chimed in about this system. If Warren was still with us (RIP), he would've been all over this....Joe

BTW, I have a repop of that bracket for a small block if you need it. HBC sent it by mistake & didn't want it returned

Thanks but these came with both mounts and brackets and some hardware was missing due to poor packing I have contacted Rich and he will be digging me up some hardware

Originally Posted by rszmjt

There is a post on CRG i was involved in regarding the original production mounts. Here is a picture of a original set of Z28 mounts i have, lift plate is a reproduction.

cool and I forgot to look on CRG -older age is great isn't it? -I found the thread there, was hoping for some measurements of through bolt spacer and washer if its handy? I have also reached out to Lloyd Edgemont as he was looking I'm pretty sure he has located it by now

[rszmjt]

Originally Posted by Zman1969

Thanks but these came with both mounts and brackets and some hardware was missing due to poor packing I have contacted Rich and he will be digging me up some hardware



cool and I forgot to look on CRG -older age is great isn't it? -I found the thread there, was hoping for some measurements of through bolt spacer and washer if its handy? I have also reached out to Lloyd Edgemont as he was looking I'm pretty sure he has located it by now

I will try to dig it out on the weekend and get the measurments.

[Edgemontvillage]

"Cool and I forgot to look on CRG -older age is great isn't it? -I found the thread there, was hoping for some measurements of through bolt spacer and washer if its handy? I have also reached out to Lloyd Edgemont as he was looking I'm pretty sure he has located it by now[/QUOTE]"


Mike (rszmjt) is your best source for the measurements on those second design mounts as I have the first design (and they're now installed on the car).

Lloyd.

[Zman1969]

Originally Posted by Edgemontvillage

"Cool and I forgot to look on CRG -older age is great isn't it? -I found the thread there, was hoping for some measurements of through bolt spacer and washer if its handy? I have also reached out to Lloyd Edgemont as he was looking I'm pretty sure he has located it by now

"


Mike (rszmjt) is your best source for the measurements on those second design mounts as I have the first design (and they're now installed on the car).

Lloyd.[/QUOTE]

Thanks Lloyd! Im going to ask your unanswered question here from the CRG thread

1. Length of the through bolt
2. Diameter and thickness of the flat washer (it appears to be extra thick)
3. Inside and outside diameters of the bright sleeve that passes through the motor mount stop bracket (best view is the first photo)

my car is a Sept 69 built car