Dedicated to the Promotion and Preservation of American Muscle Cars, Dealer built Supercars and COPO cars. |
|
#13
02-20-2022, 04:25 PM
|
|||
|
|||
I used Comp Ultra rockers, thicker cork gaskets, short poly locks and I cut about .100 off the hex head of the(4 on each side) poly lock. The clearance issue on mine was the tall row of adjusters through the center of the head. The big boxy square aluminum rockers have clearance issues, on factory covers, in the rear corners, I've been told they grind the corners of the rockers for clearance.
Last edited by wvhylander; 02-20-2022 at 04:57 PM. 
|
|
|
Threaded Mode