Dedicated to the Promotion and Preservation of American Muscle Cars, Dealer built Supercars and COPO cars. |
|
|||||||
| Register | Album Gallery | Thread Gallery | FAQ | Community | Calendar | Become a Paid Member | Today's Posts | Search |
|
|
Thread Tools | Display Modes |
|
#10
02-19-2022, 04:06 PM
|
||||
|
||||
Well, I got to got to FL for 2 weeks, but that's about 2 months short for avoiding the cold up here.
 Anyway, back on the Camaro. After agonizing for days/hours over the fit and alignment of the truck floor/tail panel brace and the tail panel and quarter fit, I finally just said it's about as perfect as I can get it. I prepped and got it welded on.   Drill screws and clamps gets it tight to the trunk floor and frame rails/tank braces.   I'm going to spot weld the top flange to the trunk floor to avoid needing to dress welds and hide them with sealer. Only issue is, my spot welder is at work and I'm not motivated enough to make a 60 mile round trip to fetch it this weekend. I'll get it home next week, as I work Mon-Wed. 
__________________
Mitch 1970 Chevelle SS 1966 Chevelle SS 1967 Camaro ss/rs 1938 Business coupe, street rod 2000 FXSTS, original owner, 13k miles 
|
| The Following 5 Users Say Thank You to Too Many Projects For This Useful Post: | ||
69M22Z (02-20-2022), big gear head (02-19-2022), jbtech (03-15-2022), olredalert (02-19-2022), tom406 (02-19-2022) | ||
|
|
Threaded Mode