Dedicated to the Promotion and Preservation of American Muscle Cars, Dealer built Supercars and COPO cars. |
|
|
|
#1
10-19-2021, 04:16 PM
|
||||
|
||||
Hi Kurt! Those look identical to my Appliance CH4s, which are for 67-69 Camaro. You can see mine on my build thread.
https://www.yenko.net/forum/showthread.php?t=161440 Last edited by Chuck_Burg; 10-19-2021 at 07:46 PM. Reason: Typo 
|
| The Following User Says Thank You to Chuck_Burg For This Useful Post: | ||
69 Post Sedan (10-20-2021) | ||
|
#2
10-20-2021, 01:32 AM
|
|||
|
|||
|
Quote:
I put a lot of those Appliance headers on in the early 70,s when I worked at a local Calgary speedshop JB,s Automotive , very nice headers very equal length too. I have a set of CH3 headers for a small block Camaro been saving them for years. FWIW when Blackjack took over they changed to that rotating lower flange. Last edited by rszmjt; 10-20-2021 at 01:34 AM.
|
| The Following 2 Users Say Thank You to rszmjt For This Useful Post: | ||
69 Post Sedan (10-20-2021), NorCam (10-20-2021) | ||
 |
|
|
Hybrid Mode
