Battery/starter question

[chevyman0429]

I found the starter grinding problem the mounting hole in the block is cracked! Not good as it’s a 69 512 block.

[earntaz]

Originally Posted by chevyman0429

I found the starter grinding problem the mounting hole in the block is cracked! Not good as it’s a 69 512 block.

Damn -- not good! It can be fixed but the process is extensive. Back in the day one method was a lot of preheat and a good welder using high nickle rod ... Good Luck!

[rszmjt]

Originally Posted by chevyman0429

I found the starter grinding problem the mounting hole in the block is cracked! Not good as it’s a 69 512 block.

If your car has the cast iron starter end housing you can always find the end housing that has the 3 bolt style, and use all 3 to retain the starter, apparently Some early BB “may” be drilled for all three, you will have to check, you could always put a stud in the cracked hole too?

I used the 3 bolt end housing before on a mid year Corvette that had that issue, it’s still good after about 5 years.

[chevyman0429]

Originally Posted by rszmjt

If your car has the cast iron starter end housing you can always find the end housing that has the 3 bolt style, and use all 3 to retain the starter, 512 blocks are drilled for all three, you could always put a stud in the cracked hole too?

I used the 3 bolt end housing before on a mid year Corvette that had that issue, it’s still good after about 5 years.

Yea that’s the plan however for now I’m gonnna use a high torque mini starter that also uses three bolts with the stud. I am on the hunt for a starter or nose of one with the three holes if anyone has any knowledge of what year and what model had this nose.

[RPOLS3]

Originally Posted by chevyman0429

Yea that’s the plan however for now I’m gonnna use a high torque mini starter that also uses three bolts with the stud. I am on the hunt for a starter or nose of one with the three holes if anyone has any knowledge of what year and what model had this nose.

3 bolt starters are correct for early 409's and maybe early 60's corvettes I believe...…...google part# 1107233 starters - I'm looking for one now.

[John Brown]

Originally Posted by chevyman0429

Yea that’s the plan however for now I’m gonnna use a high torque mini starter that also uses three bolts with the stud. I am on the hunt for a starter or nose of one with the three holes if anyone has any knowledge of what year and what model had this nose.

The three hole bolt to the block snouts were used as early as 1957 on Turboglide equipt cars. Have also seen them also used on 409's.

[Lynn]

Originally Posted by chevyman0429

I found the starter grinding problem the mounting hole in the block is cracked! Not good as it’s a 69 512 block.

OUCH. That sucks big time.