Dedicated to the Promotion and Preservation of American Muscle Cars, Dealer built Supercars and COPO cars. |
|
|
|
#1
07-10-2019, 07:54 PM
|
||||
|
||||
Are you talking about the stripes wrapping around the leading edge of the front header panel?
Usually about a 3/16 +/- is blown under the edge with most painters passing along the front edge. I don't think factory header panels were much different and likely varied as Sam stated. Once the grill stiffener is in you can't see beyond 1/4" or so. Mine ended just before the grill stiffener when looking from underneath and I think this was normal practice. 
__________________
I like solid lifter cars, big cams and cars w/ 3 pedals in them. 
Last edited by NorCam; 07-10-2019 at 08:02 PM. 
|
 |
|
|
Hybrid Mode
