Dedicated to the Promotion and Preservation of American Muscle Cars, Dealer built Supercars and COPO cars. |
|
#5
06-09-2019, 12:25 PM
|
||||
|
||||
an Earlier thread;
https://www.yenko.net/forum/showthread.php?t=120533 I have used The Parts Place black/aqua a few times sprayed out of Devilbiss Finish line gun with 1.8 tip ( no strainer or screen in cup/gun of course) with good results. Although the very first time was sent a can that had either been frozen or frozen in shipping, it performed terribly, which they replaced. Most recently picked up a can from Ausley's at spring Carlisle. not sure what happened but the spatters in the can were already small, and sprayed out small through a primer gun with 2.0 tip. Looks no better than hobby store faux granite finish or the water soluble automotive stuff that comes in a buzz-bomb. I contacted The Parts Place to inquire if supplier or product had recently changed and got nowhere....pretty disinterested in my experience, not sure I'll get anywhere with Ausley's either. But I would still use this product over any other.
__________________
Dave C. 68 SS396 Camaro 69 SS396 CB Chevelle Conv. 70 340 Dart Swinger 70 SS396 Chevelle 4spd 70 SS396 Chevelle 70 BB 4spd Monte Carlo 70 SS454 Monte Carlo 71 SB 4spd Monte Carlo 71 SS454 Monte Carlo 71 Corvette LS-5 conv. 71 Corvette LT-1 conv. 71 Corvette LS-6 coupe 72 Monte Carlo 72 Monte Carlo Custom 72 442 W-30 clone 76 Trans Am SE 455 4 spd 85 Mustang GT Conv. 86 Grand National 02 SS conv. 
Last edited by DaveC68; 06-09-2019 at 12:31 PM. 
|
|
|
Threaded Mode