Dedicated to the Promotion and Preservation of American Muscle Cars, Dealer built Supercars and COPO cars. |
|
|||||||
| Register | Album Gallery | Thread Gallery | FAQ | Community | Calendar | Become a Paid Member | Today's Posts | Search |
|
|
Thread Tools | Display Modes |
|
#2
03-08-2019, 01:28 AM
|
|||
|
|||
Easiest way to tell is look at the side edge at rear of hood , repo hoods end in a small approximately 45 degree angle. GM hoods have a small notch out of the 45 degree angle. Production line installed hoods also have a week production code stamped in the drivers side at the rear by notch. Hope that helps somewhat
|
| The Following User Says Thank You to rszmjt For This Useful Post: | ||
big gear head (03-08-2019) | ||
|
|
Threaded Mode