Going Day II with my Z/28

[NorCam]

Recently I was put in touch with Nate at Sweet Ave Fabrication in North Dakota. He bought the dies and tooling to continue reproducing M/T Scavenger style collectors for those wanting a custom set of equal length headers. While most of the ones he's been doing have been for big blocks, he's now making a set for my mouse motor with 1-3/4" tubes and the custom made collectors to fit a F-Body SBC with power steering and a Muncie. They are built using an original front sub-frame and steering so that the headers are perfectly clearance'd to fit the car. Once completed they are sent off to Minnesota to be Ceramic coated (in orange of course). These are gonna sound cool behind the new Crossram motor with that ping pong ball sound inside the chambers.

[scuncio]

Cool, any idea what he gets for the 67-69 BB Camaro headers?

[Schonyenko2]

That is very cool.

[mockingbird812]

Dang, that’s HOT!!!!!

[Tommy]

Originally Posted by NorCam

Recently I was put in touch with Nate at Sweet Ave Fabrication in North Dakota.

Tell Nate that his Welding table is outstanding!! I


Tommy

[NorCam]

Originally Posted by Tommy

Tell Nate that his Welding table is outstanding!! I

Tommy

I talked with Nate today and he chuckled when I read this to him. I had a set of engine mounts shipped to him yesterday and he's now mocking up a small block in a 69 sub frame to get all the clearances right on these headers. He's going to add some 02 bungs so tuning the carbs will be a little easier once the Crossram is added. They should be finished up and sent off for ceramic coating next week.

[napa68]

This folks......................header porn!

Originally Posted by NorCam

Recently I was put in touch with Nate at Sweet Ave Fabrication in North Dakota. He bought the dies and tooling to continue reproducing M/T Scavenger style collectors for those wanting a custom set of equal length headers. While most of the ones he's been doing have been for big blocks, he's now making a set for my mouse motor with 1-3/4" tubes and the custom made collectors to fit a F-Body SBC with power steering and a Muncie. They are built using an original front sub-frame and steering so that the headers are perfectly clearance'd to fit the car. Once completed they are sent off to Minnesota to be Ceramic coated (in orange of course). These are gonna sound cool behind the new Crossram motor with that ping pong ball sound inside the chambers.

Here's a sound clip link to Youtube.