Quote:
Originally Posted by 169indy
I got frustrated with a VENDOR (NOT to be named Not bashing) service provider a few years ago. I worked to find a source for the internals and built special tooling and used 3/4" sockets etc and my 10ton press to rebuild my own. It has taken a bit of trial and error Oh yes some goofs.... Nice to find dated cores at swap meets for $30.oo,,,Just a sample of DIY.
Jim
|
You make me VERY nervous pressing bearings in that way. Those ears are very thin wall and will snap easily. Better to support on the rear cover surface.
08-13-2017, 07:12 PM
Threaded Mode