'69 L78 Water Pump rebuild - Page 3

**mockingbird812** · #21 03-16-2016, 03:52 PM

Ha, you have a good point there Rick! [img]<<GRAEMLIN_URL>>/biggthumpup.gif[/img]

No joy from Goulds for a correct pump.

Found this statement on the "infallible" internet: "In April of 1969 a modification was made to pump #065 and it was assigned a new casting number (#3969811). " Is this true? If so I may be able to use an 811 from April/May.

Thanks,

m22mike · #22 03-16-2016, 06:03 PM

Sam
This was on the 03E COPO

and this on my 05A L78

**mockingbird812** · #23 03-16-2016, 06:26 PM

That seems to support the statement I read. So his "811" on ebay should be correct. Anyone know this fellow?

**WILMASBOYL78** · #24 03-16-2016, 07:29 PM

I will always defer to the 'gurus' of the SYC... [img]<<GRAEMLIN_URL>>/worship.gif[/img]

But, isn't that component date a little too close to the engine assembly date? I don't know where the water pumps were produced and/or how long it took to get them to the engine plant...but, there are only 4 days between the pump and the engine. I would think a little more time would have been needed...we are talking about 1969, things didn't happen that fast...or did they??

wilma [img]<<GRAEMLIN_URL>>/hmmm.gif[/img]

**mockingbird812** · #25 03-16-2016, 07:34 PM

You may have a good point Tom. Anyone, anyone, Ferris!!!!!!!!!!!!!!!!!!!

BTW if you cant get to the ebay link, the one for sale is a rebuilt "811" with a cast date of May 19th and my engine was assembled on May 23rd.

Nova Jed · #26 03-16-2016, 08:15 PM

I know that this doesn't pertain to BB pumps, but I had luck with some reman pumps from NAPA that codes and dates were close for my small blocks. Cheap too. Had one apart to find the cheap finned sheet metal impeller, but oh well. The only reason I went that route was because new pumps would throw pulley alignment out by 1/8 of an inch. Passed that on to my boss when we had to replace pumps. Sorry for the hi jack.

**mockingbird812** · #27 03-17-2016, 01:13 AM

I need a couple of the metal nipples that thread into the two small threaded orifices (center top in this photo)

**Big Block Bill** · #28 03-17-2016, 02:26 AM

AMK Products sell a nice set in a pair package, $20.00 ?

Bill

m22mike · #29 03-17-2016, 02:51 AM

Sam
Also, check out the performance stainless fittings if your not concerned about concurs correct, there very nice quality. Here is a kit, or you can buy them separate.

Kool kitz 1032

Mike

**enio45** · #30 03-17-2016, 04:47 AM

rick nelson rebuilt a water pump for me...:-)

Dedicated to the Promotion and Preservation of American Muscle Cars, Dealer built Supercars and COPO cars.