Go Back   The Supercar Registry > Classified Section > Parts/Memorabilia - For Sale

Please note


 
 
Thread Tools Display Modes
Prev Previous Post   Next Post Next
  #5  
Old 04-21-2014, 11:30 PM
Lynn Lynn is offline
Yenko Contributing Member
 
Join Date: Feb 2005
Location: Oklahoma
Posts: 7,879
Thanks: 104
Thanked 3,673 Times in 1,547 Posts
Default Re: 69 Z/28 or small block ducted hood coil bracket

A member sent me a PM questioning whether these were correct.

He did not think the angle was deep enough, and questioned whether they should have the notch on top.

I believe the notch theory has been debunked by JohnZ, whose survivor car has no notch in the bracket.

I put an inclinometer on a standard bracket and it measured about 20 degrees.

These measure 28 to 30 degrees. I have seen reports (haven't actually measured one) that it should be between 30 and 35 degrees.

Just want to be sure you guys are ok with that.

Even if you decide after the fact, I would give a full refund.

I will include this message in my pm to each of you.

Lynn
__________________
Don't believe everything you read on the internet ... Ben Franklin
Reply With Quote
 

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT. The time now is 11:36 AM.


Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2025, vBulletin Solutions Inc.