Plexiglass scoop

[MosportGreen66]

like this?

[whitetop]

Here is the Northeast Performance scoop-about 8" tall and 1-2 inches longer than the A&A scoop

[brent396]

Very cool scoop someone should redo some plexiglass scoops

[PxTx]

<div class="ubbcode-block"><div class="ubbcode-header">Originally Posted By: brent396</div><div class="ubbcode-body">Very cool scoop someone should redo some plexiglass scoops </div></div>

I'm looking into this, but a mold needs to be made. What would you guys think, a clear Grump Lump may be the best design? Probably only gonna make 1 run and be done. Not really looking to saturate the market and water down the &quot;cool factor&quot;.

Most likely gonna just do clear, then you can Candy paint them to add color.

[whitetop]

<div class="ubbcode-block"><div class="ubbcode-header">Originally Posted By: pxtx</div><div class="ubbcode-body"><div class="ubbcode-block"><div class="ubbcode-header">Originally Posted By: brent396</div><div class="ubbcode-body">Very cool scoop someone should redo some plexiglass scoops </div></div>

I'm looking into this, but a mold needs to be made. What would you guys think, a clear Grump Lump may be the best design? Probably only gonna make 1 run and be done. Not really looking to saturate the market and water down the &quot;cool factor&quot;.

Most likely gonna just do clear, then you can Candy paint them to add color. </div></div>

Paul, smoke plexiglass also look nice.


What kind of prices have you received? Did you see what I was quoted above? Of course the two co's that I approached were very large co's that deal with large corporate orders and they did not really want to mess with my small job and many co's do not have the set up to do 1/4&quot; thick plexi

The 1/4 after forming gets kinds thin...I'm not sure I would do anything less than that-engine heat might distort anything thinner????