Dedicated to the Promotion and Preservation of American Muscle Cars, Dealer built Supercars and COPO cars. |
|
|
|
#1
07-01-2010, 05:54 AM
|
|||
|
|||
sheet metal
How is the aftermarket sheet metal for a 1968 Camaro??? (thinking of Good-mark)
[img]<<GRAEMLIN_URL>>/confused.gif[/img] Will it line up and come out right??? Or should I try to find NOS metal? 
|
|
#2
07-01-2010, 12:19 PM
|
|||
|
|||
|
Re: sheet metal
I haven't used any myself, but there is a body shop forum at www.camaros.net where they have discussed repop stuff in detail. You may want to have a look there. Good luck.
__________________
Tony 55 Nomad Gasser 70 SS 427 Nova 34 Ford Sedan..Hemi powered Michigan/ Florida
|
|
#3
07-01-2010, 09:26 PM
|
|||
|
|||
|
Re: sheet metal
Do you need fenders? Quarters? I would stay away from doors, the other parts are hit and miss. I have seen hoods go right on one time then 1/4 inch to wide the next. One fender I had to take the inner brace off the outer skin and weld in the correct position. The quarters Ive fought for days. Some n.o.s. parts don't fit either though. Dustin.
|
 |
|
|
Hybrid Mode
