chambered exhaust

[olredalert]

------You can get the exhaust sleeve you want from any of the big vintage Corvette parts houses. I just got a couple from Long Island Corvette. I ordered mine out of the catalog by phone, but they probably have a very good comprehensive website.......Bill S

[mockingbird812]

[ QUOTE ]
------You can get the exhaust sleeve you want from any of the big vintage Corvette parts houses. I just got a couple from Long Island Corvette. I ordered mine out of the catalog by phone, but they probably have a very good comprehensive website.......Bill S

[/ QUOTE ]

Yeah, Bill, "...ordered mine out of the catalog by phone, but they probably have a very good comprehensive website..." That's old school man!

Website ordering is for SISSIES!!!

[RPOLS3]

This what you're looking for?

http://www.parts123.com/parts123/yb.dll?...~Z5Z5Z50000370a

[Keith Tedford]

Our '69 big block, driver side manifold has the same sleeve setup.

[sg1747]

no mine is about 6 inchs long and slids down inside the exhaust.

[61 vert]

Didn't know that they had those on cars, but I believe that the C-50 and larger trucks had that sleeve that centered the donut and kept the heat and flame of the donut. Trucks run alot hotter on the exhaust side when pulling a heavy load.

[olredalert]

------John,,,Im wondering if your 6 inch long peice is the original, or if its a cobbled version. As far as I know the shorter one pictured would be correct, and in any event would work just fine. It only sticks up out of the exhaust pipe far enough to keep the donut from collapsing inward as you tighten the bolts after all.......Bill S

[sg1747]

it does say 63 to 67 but for 8.00 i will give it a shot.was going to take it apart tonight but 2 feet of snow on its way.have to plow that sucks.sorry am i allowed to say that on here.