Dedicated to the Promotion and Preservation of American Muscle Cars, Dealer built Supercars and COPO cars. |
|
|||||||
| Register | Album Gallery | Thread Gallery | FAQ | Community | Calendar | Become a Paid Member | Today's Posts | Search |
|
|
|
Thread Tools | Display Modes |
|
|
|
#1
01-13-2010, 05:44 PM
|
|||
|
|||
Re: TANK STICKER CORVETTE
[ QUOTE ]
The best way is to leave it on the tank and install another tank. Just a opinion.... [/ QUOTE ] There's a good chance the tank has pin holes on the bottom anyway. I hardly ever saw a Corvette tank that didn't have an inch or so of water in the bottom. I had to replace the tank in my '68 and still have it (with the sticker attached) stored above my garage. The car is long gone but much of the stuff I replaced is still around. BTW, Anyone need a complete smog pump and brackets for a '68 427 Corvette? 
__________________
Don't mistake education for intelligence. I worked with educated people. I socialize with intelligent people. 
|
|
#2
01-13-2010, 06:03 PM
|
||||
|
||||
|
Re: TANK STICKER CORVETTE
Maybe be off the topic a bit, but if one choses to cut or repair a tank, after it is cleaned out, through in a few pounds of dry ice. That will displace the 02 and may keep you off the local news too.
I have seen some old welders ( like Shoney.  ) use this trick on small aircraft tanks.
|
|
|
|
Hybrid Mode
