![]() Dedicated to the Promotion and Preservation of American Muscle Cars, Dealer built Supercars and COPO cars. |
|
#1
|
||||
|
||||
![]()
Check the short sections of rubber fuel hose that connect the steel lines by the subframe, by the tank and from the steel lines to the pump inlet. I have seen some old rubber hoses delaminate/seperate internally and then collapse when suction is applied from the pump. They may look fine from the outside but could be completely blocked inside.
|
#2
|
|||
|
|||
![]()
Fixed, pump was fine. My guess is this, all the fuel drained out of the Holley bowls and the majority of the f/p itself. When the engine stopped, did the f/p pump shaft off the cam leave the pump in an open position.? I don't know if that is even possible. I dumped some fuel into the carb, fired the motor, and that evidently created enough vacumm to get the whole system functioning normally again, no problems since, very funky, never had that happen before. Thx for the tips. SULLY
__________________
70 L78 Nova Fathom Blue,Bench, 4spd, F41, 3:55 71 Porsche 911 Targa |
![]() |
|
|