Go Back   The Supercar Registry > General Discussion > Technical & Restoration


 
 
Thread Tools Display Modes
Prev Previous Post   Next Post Next
  #16  
Old 02-01-2009, 02:50 AM
beater68427 beater68427 is offline
Senior Member
 
Join Date: Jan 2009
Location: Utah
Posts: 577
Thanks: 5
Thanked 0 Times in 0 Posts
Default Re: Need Pic F body 12 bolt BE

[ QUOTE ]
The lower E means it had an Eaton posi unit in it. Note that that E looks similar to the E in BE. Hard to tell from the angle, but I'd check it out anyway. Casting date seems early for COPO, though.

[/ QUOTE ]

I ran a pencil over the E for eaton today and the E in the BE they are identicle type set, but the E is deeper stamp on the eaton, most of the numbers on the tube seem to fade at top, Im guessing the roll of the tube?? I did pull it apart today to clean next week and set the gears up in it. I have not found anything on the internet that "BE" was to specific to "COPO" but just 4:10 gear ratio and possibly a service part??? I do not know I'm no expert on this. The car does have a multitude of what seems to be "counter parts" I just figured this was the same as well...
__________________
Reply With Quote
 


Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT. The time now is 07:11 PM.


Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2025, vBulletin Solutions Inc.