Need some Critique on my 69

[Jerry@CHP]

Joe,

Sorry about that. Somehow we got side tracked talking about the upper control arm shafts.

Jerry

[Bad Brad]

Sorry no new pictures today I was lazy, get some tomorrow.

[Jerry@CHP]

Brad,

Were you able to find an oil cap?

Jerry

[Jerry@CHP]

Forgot, I have them at my shop because we do so many big block engine rebuilds. Let me know if you can't find one.

Also, do you have the nice Crane reproduction valve covers? They are $$$ but right on the money. Only thing you have to do on the 69 Crane covers is install the rubberizing material on the lower clip.

Jerry

[Bad Brad]

I found an oil cap. I know the crane valve covers are big $$ how much are they now days?
I made my temp sensor clip for the valve cover.
I had to go cheap some place. LOL

Now to get up off my lazy arse and take some new pictures.

[Jerry@CHP]

Year One had a special running on those covers. 20% off, put them in the $300+ range. You still need to rubber dip the clip. That liquid rubber is available at Home Depot. Did you do that on the clip that you have on the current valve covers?

Good luck,

Jerry

[SS4Real]

Jerry,

Whose valve cover gaskets are you using for those valve covers?

[Jerry@CHP]

Mr. Gasket #177, paint them silver and you're good to go.

Jerry

[Bad Brad]

I have some of the liquid rubber I can do it with.
Well I was going to take some pictures but my batteries are dead and now charging up.

[Bad Brad]

Any one have a picture of the dipped clip on the valve cover with it attached?