Dedicated to the Promotion and Preservation of American Muscle Cars, Dealer built Supercars and COPO cars. |
|
|
|
#1
03-01-2021, 01:11 AM
|
||||
|
||||
I can appreciate the sacrifice someone would make to run a 'dated' component to have the correct appearance, but in this case when the performance of said part is so dismal, I'm amazed the vendor hasn't totally revised the design.
|
| The Following User Says Thank You to scuncio For This Useful Post: | ||
X66 714 (03-01-2021) | ||
|
#2
03-01-2021, 01:56 AM
|
||||
|
||||
|
Agree ^^^^^
I’m sure Quanta has heard the complaints over the years, just how we have in this small thread about the belts they make.
That’s reproduction parts in a nut shell, close, but not close enough.
|
| The Following User Says Thank You to 60sStuff For This Useful Post: | ||
X66 714 (03-01-2021) | ||
|
#3
03-01-2021, 02:19 AM
|
||||
|
||||
|
Thank you all for taking the time to discuss these belts. Although my car is just a 325hp 396, I think I will try to find older aftermarket belts that don't have cogs on either top or bottom. My a/c belt is an older Gates belt & has held up well. I will figure out the other 2. I really didn't expect this much responce. Thanks again, Joe
__________________
1968 Z/28 Corvette Bronze. Black Hounds Tooth. 02E Los Angeles born 3/13/1968 pnt OO 1969 SS396 Yellow/Yellow 08E Norwood born 8/28/1969 pnt 76E 1970 'cuda Moulin Rouge, 440-6, 4 speed
|
| The Following User Says Thank You to X66 714 For This Useful Post: | ||
60sStuff (03-01-2021) | ||
 |
| Thread Tools | |
| Display Modes | |
|
|
Hybrid Mode
