Dedicated to the Promotion and Preservation of American Muscle Cars, Dealer built Supercars and COPO cars. |
|
|
|
#1
02-07-2009, 11:28 PM
|
||||
|
||||
Re: Hurst Shifter
On the same muncie trans? I think the handle might be different because the motor and trans are located one inch to the right for BBC.
__________________
|
|
#3
02-08-2009, 12:49 AM
|
|||
|
|||
|
Re: Hurst Shifter
|
|
#4
02-08-2009, 01:05 AM
|
|||
|
|||
|
Re: Hurst Shifter
I got an original 69 camaro Hurst Shifter, I seen where there is a difference b/t the big block one and small block one. I was trying to figure out what I got.
|
|
#5
02-09-2009, 12:56 AM
|
|||
|
|||
|
Re: Hurst Shifter
I believe the shifter and handle are exactly the same for bb vs. sb. The difference is the mounting bracket as shown in RPOL88's auction, and the rods. Since the bb shifter is about 1/2" further away from the tranny than the sb one, the rods are bent just a little differently.
|
|
#6
02-09-2009, 03:01 AM
|
|||
|
|||
|
Re: Hurst Shifter
Thanks I think I got a set of BB rods and linkages. Are the rods any thicker?
|
|
#7
02-09-2009, 03:51 AM
|
|||
|
|||
|
Re: Hurst Shifter
Here's what I think I know. SB and BB rods are the same diameter. The correct BB rods are numbered. SB are not. Both sets are longer than the aftermarket Hurst rods. Rev. is 9" 1st. & 2nd. is 14 3/4" 3&4 is 17 1/2".3&4 uses a fine thread. (3/8ths.-24). The factory 9 hole & the BB mounting brackets lower the position of the shifter on the transmission. Both brackets have an elongated hole for the bottom bolt that allows you to pivot the shifter for your desired location. Let me know if I need to be corrected. Thanks, Tom.
|
|
#8
02-09-2009, 05:29 AM
|
||||
|
||||
|
Re: Hurst Shifter
[ QUOTE ]
On the same muncie trans? I think the handle might be different because the motor and trans are located one inch to the right for BBC. [/ QUOTE ] Shifter to trans mounting bracket is different on BB to accomodate offset, along with different rods.
__________________
Steve Shauger The Supercar Registry www.yenko.net Vintage Certification™ , Providing Recognition to Unrestored Muscle Cars. Website: www.vintagecertification.com
|
|
#9
02-09-2009, 06:02 AM
|
|||
|
|||
|
Re: Hurst Shifter
Sounds like logical information. I'll take a look at the one I got tomorrow and I'll see if it is consistant to yours specs.
|
|
#10
02-11-2009, 02:04 AM
|
||||
|
||||
|
Re: Hurst Shifter
Since it was easy to take a picture, I'm posting mt Comp Plus shifter assembly for a 69 Nova. I'd like to see a picture of a factory setup for both BB SB if anyone's got them.
Excuse the tow tabs, I'm practically tripping over them these days  
__________________
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Hybrid Mode
