Dedicated to the Promotion and Preservation of American Muscle Cars, Dealer built Supercars and COPO cars. |
|
#7
03-16-2009, 08:43 PM
|
||||
|
||||
Re: Fuel Pump Metallurgy
If this topic has run it's course, perhaps I can migrate to a similar issue:
How is/are the fittings attached to the anodized portion of the pump? I have an NOS pump for my deuce, and after installation it leaked like a fountain, (Pittsburgh WoW show!). Turns out, the 'block' fitting has a small split where it attaches to the base, apparently not completely attached when initially assembled. I've thought about epoxy, but would like a more permanent solution - if any??
__________________
Marlin 70 Yenko Nova-350/360, 4speed M21, 4.10 Posi (Daddy's Ride) 69 SS Nova-396/375hp, 4speed M20, 3.55 Posi (Benjamin's Ride) 67 RS Camaro-327/250hp, 2speed Glide, & 3.08 Open (Danny's Ride) 
|
| Thread Tools | |
| Display Modes | |
|
|
Threaded Mode