69 396 ss camaro

redbaron · #1 02-07-2002, 11:33 PM

Hello all
Can anyone tell me if any 69 396 ss camaro came with a 10 bolt rearend. I'm a new member and sure like this site. Have loved yenkos and copos for years, just not rich enough to own one yet! Thank You

**Stefano** · #2 02-08-2002, 12:30 AM

Anything is possible, but it is very unlikely. I have howeve,r seen an early 1967 SS 350 A/C car with a 10 bolt non posi which was coded correctly and believed original.

redbaron · #3 02-08-2002, 12:50 AM

Thanks Stefano
I was sure that was the case. I'm looking at a car that appears to be an original 69 396 SS, but it does have a 10 bolt.It has the right hood,heater core,etc. Thanks Again

Rat_Pack · #4 02-08-2002, 01:58 AM

I would question it as I have not seen a big block Camaro with a 10 bolt from the factory until 1971. Check the stamping on the rh axle tube on the leading edge. Contact the CRG at www.camaros.org and give them the information. They can help you the best. It is possible that it is an SS396 but that the rear end has been changed..................RatPack...............

redbaron · #5 02-08-2002, 02:30 AM

Thanks RatPack
The car has a nom big block in it now, but a 69 396 also comes with the car. Can anyone help me on the stamped and casting numbers info. Much appreicated.

**bkhpah** · #6 02-08-2002, 02:45 AM

Check out the rear leaf springs. Five leaf is what I would expect...BKH

Dedicated to the Promotion and Preservation of American Muscle Cars, Dealer built Supercars and COPO cars.