Re: 69 Z/28 or small block ducted hood coil bracket
A member sent me a PM questioning whether these were correct.
He did not think the angle was deep enough, and questioned whether they should have the notch on top.
I believe the notch theory has been debunked by JohnZ, whose survivor car has no notch in the bracket.
I put an inclinometer on a standard bracket and it measured about 20 degrees.
These measure 28 to 30 degrees. I have seen reports (haven't actually measured one) that it should be between 30 and 35 degrees.
Just want to be sure you guys are ok with that.
Even if you decide after the fact, I would give a full refund.
I will include this message in my pm to each of you.
Lynn
__________________
Don't believe everything you read on the internet ... Ben Franklin
|