Thread: Original solid cam vs. full solid roller
View Single Post
  #14  
Old 03-27-2014, 02:52 PM
VintageMusclecar's Avatar
VintageMusclecar VintageMusclecar is offline
Senior Member
  
Join Date: Jul 2003
Posts: 3,369
Thanks: 185
Thanked 186 Times in 48 Posts
Default Re: Original solid cam vs. full solid roller
The 143, soft break-in springs and a set of GOOD EDM lifters and you should be fine. A roller does eliminate the hassle & worry of breaking in a flat tappet, but at roughly 3X the cost.

Several roller rockers will work under OE covers. One of the *tricks* is to use a set of short Crower poly locks on the intake rocker studs and use a thick valve cover gasket.

I can help with whatever parts you may need if you'd like, just send me a PM.

Eric
Reply With Quote