WANTED ORIG 70 CHEVELLE BIG BLOCK VALVE COVERS
 

I would like to find a set of original valve covers with good to exc chrome.The drivers side should have the two clips for the TCS wires and the pass side should have one clip for temp sending unit.

Thanks
Ray

Re: WANTED ORIG 70 CHEVELLE BIG BLOCK VALVE COVERS
 

I may have what you need, in OK to good condition. (I personally would rechrome) Anyway, what should the firewall side end of the driver side one look like...I have several, including the raised bump, the silver dollar flat, or the flattened corner.

Re: WANTED ORIG 70 CHEVELLE BIG BLOCK VALVE COVERS
 

Correction the pass side should have the 2 TCS clips and the driver side has the one clip for temp. sender.

Ureal,not sure how to describe it to you.It will have an slight slant toward one corner.Do you have any pictures of the ones you have?

thanks
Ray

Re: WANTED ORIG 70 CHEVELLE BIG BLOCK VALVE COVERS
 

I have the following:
Pass- 2 sparkwire towers, 2 inside clips, 1 outside clip
Pass- no towers, no clips
Pass- 2 towers, no clips

Driver- 2 towers (chevelle position) 1 outside clip, slanted rear with bumpout on top inside.

Driver- 2 towers (chevelle position,) no clips, slanted rear with bumpout on top inside.

All need minor dolly work, and rechromed, all have drippers.


Driver- 2 towers (chevelle position, but unattached) no clips, slanted rear with bumpout on top inside.

Driver- 2 towers (camaro position) outside clip, slanted rear with small flat at 60* on bottom outside.

Driver- 2 towers (chevelle position, but unattached) 2 inside clips, straight rear with silver dollar flat on top outside.

Re: WANTED ORIG 70 CHEVELLE BIG BLOCK VALVE COVERS
 

Unreal,I have a lead on a pair.I will let you know if it falls through.

thanks
Ray

Re: WANTED ORIG 70 CHEVELLE BIG BLOCK VALVE COVERS
 

Curious if anybody reading this thread has knowledge of replacing broken off wiring securing "clip".....and is there any way to restore the FLASH chrome....versus full on SHOW chrome.....Chuck S Seattle

Re: WANTED ORIG 70 CHEVELLE BIG BLOCK VALVE COVERS
 

I'm also interested in an answer to this question. I have a one that has a short spark plug tower missing and one that has a crack in it from a dent. Both covers will need to be rechromed.

Re: WANTED ORIG 70 CHEVELLE BIG BLOCK VALVE COVERS
 

I thought this was covered.
https://www.yenko.net/ubbthreads/show...rev=#Post20969
Is there any updates since? https://www.yenko.net/ubbthreads/imag...lins/dunno.gif