Dedicated to the Promotion and Preservation of American Muscle Cars, Dealer built Supercars and COPO cars. |
|
|||||||
| Register | Album Gallery | Thread Gallery | FAQ | Community | Calendar | Become a Paid Member | Today's Posts | Search |
|
|
Thread Tools | Display Modes |
|
#8
08-26-2016, 02:03 AM
|
||||
|
||||
Re: Machinist's advice sought
Had a stud issue like above on a set of 462's. I should have been running screw in studs. Have the mount milled down and threaded for screw in studs. Mag the boss after machining to make sure the crack is gone. The pin hole SHOULD have stopped the crack, I would be surprised if it went below the hole.
BIG 
|
|
|
Threaded Mode