what was the correct Power booster plating

[1cool13L78]

Thanks everyone.. learned a lot and now know what to do... [img]<<GRAEMLIN_URL>>/flag.gif[/img]

Steve has done work on my "junk" in the past, and I'm positive, he'll get the nod in the future too. My Nova project will definitely use his pieces. His work is first rate as far as I'm concerned, and at least in my book, a good guy too.

Wayne Scraba

[SS427]

Steve has done most of my plating for close to 10 years. I cannot recall ever being dissatisfied with the results.

[Ngtflyr]

Steve,

I will call you tomorrow. Our order was less than a year ago, I'm sure you will remember it. We sent in at least five boosters with five very different results. Also sent some other stuff, hinges, latches etc. Problems were with the initial call we got back from you and results two of the boosters, one booster in particular that needs redone. Love to discuss it.

[Ngtflyr]

For the record, I did receive the wrong upper(male) portion of the hood latch, not sure what car it was for but was definitely the wrong one, holes didn't line up to the hood. Steve, had me send it back and after his next plating run sent me the correct one back, if I remember right he covered the ride too. For this reason I didn't post anything negative earlier.