Pertronix Ignitions

[JRSully]

Use a Crane unit and it works flawlessly thus far, but will keep a set of points in the glove box, you never know

[DarrenX33]

I have had good luck with the Crane unit. The built in rev limiter is nice to.

[Chevy454]

Be careful of the rev limiter in the Crane units...I know a couple of folks that have had issues with it kicking in sporadically. As for the Pertronix, they're good when they work...but I've been stranded several times in a couple different cars and eventually took it out.

Sammy, you'll be glad to know, a certain Pure Stocker tested a Pertronix versus points system...the points made more power!

[SmallHurst]

I have the Ignitor 2 set up with the matching coil. My inital setup had no issues until I had the positive battery cable popped off and the coil unloaded through the module. Can you say fried bakealite??? No issues with my stuff, just have to treat it like a diesel with glowplugs. Turn the key and let the coil saturate before cranking!!!

[Salvatore]

[ QUOTE ]
Be careful of the rev limiter in the Crane units...I know a couple of folks that have had issues with it kicking in sporadically. As for the Pertronix, they're good when they work...but I've been stranded several times in a couple different cars and eventually took it out.

Sammy, you'll be glad to know, a certain Pure Stocker tested a Pertronix versus points system...the points made more power!

[/ QUOTE ]SEE!

[DarrenX33]

[ QUOTE ]
Be careful of the rev limiter in the Crane units...I know a couple of folks that have had issues with it kicking in sporadically. As for the Pertronix, they're good when they work...but I've been stranded several times in a couple different cars and eventually took it out.

Sammy, you'll be glad to know, a certain Pure Stocker tested a Pertronix versus points system...the points made more power!

[/ QUOTE ]

I wonder if Pete G has seen that problem in his Yenko. I know he uses the Crane unit. At least he was using it when he recommended it to me. Dru, what do you use?


[ QUOTE ]
I know! However, these products are allowed and even encouraged with the pure stock drag racing community.


[/ QUOTE ]

Do they use rev limiters? If so, what kind?

[YENKO DEUCE REGISTRY]

Not sure about rev limiters....

[scuncio]

The Pertronix systems were unreliable in my experience. IMO the single-wire M&H ignition kit is the best retrofit kit on the market. For me, it's M&H or points, or MSD if I don't care what it looks like.

[ANDY M]

I have the Crane unit with a Pertronix coil. Crane has a built in rev limiter, all you need is a screw driver.

[Johnny Horsepower]

[ QUOTE ]
The Pertronix systems were unreliable in my experience. IMO the single-wire M&H ignition kit is the best retrofit kit on the market. For me, it's M&H or points, or MSD if I don't care what it looks like.

[/ QUOTE ]

I have Pertronix in a couple of cars and love it. No problems, knock hard on wood, yet. Does the crain unit have the total oe look that the pertronix does? If so,where can you get it, and what cars can I use it on.

JOHN