Smog pump disassemble

Home: Goto Homepage.
Subscribed: See all threads you’ve posted in or started.
Today's Posts: Posts made today. Bold = unread.
New Posts: Shows all unread posts since last visit.
New Thread: Newest threads by creation time.

**wundercluck** · #1 01-13-2008, 11:47 PM

The 2 holes on either side of the bearing were used to inject a plastic that surrounded the bearing and retained it to the pump body- same principle as some newer u-joint caps. I would think that heating it would help, but you may need to press it out.

m22mike · #2 01-14-2008, 01:29 AM

Wondercluck
Thats what I kind of figured out, those two holes have a plastic material in them.
Mike

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Hybrid Mode Switch to Threaded Mode

Dedicated to the Promotion and Preservation of American Muscle Cars, Dealer built Supercars and COPO cars.