Go Back   The Supercar Registry > General Discussion > Technical & Restoration


 
 
Thread Tools Display Modes
Prev Previous Post   Next Post Next
  #33  
Old 12-21-2007, 07:40 AM
Schonyenko2 Schonyenko2 is offline
Senior Member
 
Join Date: Dec 2001
Location: Donahue, Ia. USA
Posts: 2,997
Thanks: 93
Thanked 100 Times in 55 Posts
Default Re: Replicating Factory Spot Weld Appearance

I would bet that if you checked the blue print, and counted the welds on the piece, you may come up short on the welds on the piece. When you ran piecework, sometimes short cuts left off a few here and there. Keith, we used to file spot points, but later on got air dressers. They looked kinda like air ratchets except there were circular cutters where the ratchet end would be. They worked fine unless you cut to deep and the point got to thin. Then it would blow out, and shoot water all over the place.
Reply With Quote
 

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT. The time now is 11:49 AM.


Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2025, vBulletin Solutions Inc.

O Garage vBulletin Plugins by Drive Thru Online, Inc.